Nokia X6 Full PCB Diagram Mother Board By cell firmware

Nokia X6 Full PCB Diagram Mother Board.
Here is the diagram of Nokia X6 PCB.so i will add some more diagram in high resolution so that you can add some more repairing trick for

High Resolution

Nokia X6 Charger Not Supported Not Charging Problem Ways Solution Jumpers By cell firmware

if we plug in the charger to the X6 and it shows error loader not supported in this particular case, the loading pin works fine, the guilt of two important things on his charger is your first step to change the charger when not charging ok.

some working time may be the reason for janiuan charger charger charger janiun problem.if supported it may be that you 47k this resistance is defined in schedules attached to this post.so remove this resistor and a new one to replace Nokia on board for change.

Nokia X6 LED LCD light problem solution jumpers ways By cell firmware

If the light is not workin in the X6 and LCD monitor or keyboard did not work then you can solve this problem by following these few steps that I am writing this post.

just look at the schedule given by post in there are two lines going from LCD jack check this links and also verify that all components are enlined with multi colors all these parts are used in LED lighting and LCD light function in the Nokia x6.so replacement this or parts supplied to LED Light problem and dim-lit LCD display problem in the X6.

Nokia X6 Network Problem Signal Ways Solution Jumpers By cell firmware

If X6 network problem or a low signal problem in your mobile solution you can do the following diagram with this post.look attached to the chart and you can see a few items in red

and the various colored lines of the components used in the network function in the Nokia x6.clean these components if there is no water damage or rust than enables the board to dry under electric light bulb for a few coins, so it can be dry or use low heat with hot air, you may need to change these parts, if not solve the problem with just cleaning and service process.

Nokia x6 power switch button ways jumpers solution problem By cell firmware

if charging is ok but not getting power on nokia x6 it means the power switch is not working ok so you have to change power switch button in this situation in nokia x6.if power button is damage and prints are also damage this diagram is too much useful it this condition.so make these jumpers as shown in diagram attached with this post.


for more detail and new tips and tricks about this problem keep visiting this page we will update it timely with new diagrams.some related post are also given bellow you can read them also for more information.